Freud Saw Blades

Two numbers: the blade diameter and the arbor (bore). Both are printed on your current blade and in the saw’s manual. Most table saws and 10" miter saws take a 10" blade with a 5/8" arbor; 12" miter saws take 12" × 1"; corded and cordless circular saws take 7-1/4" × 5/8" with a diamond knockout; European sliding table saws take 30mm bores with pinholes. Filter this shop by diameter and arbor and every blade shown will fit.

Fewer teeth cut faster and clear chips better; more teeth leave a smoother edge. Use 24 teeth for ripping solid wood, 40–50 for general purpose and combination work, 60–80 for crosscutting trim and plywood, and 80–120 for melamine, laminate, veneer and aluminum.

ATB (alternate top bevel) teeth shear fibres for clean crosscuts in wood. FTG (flat top grind) teeth chisel through ripping cuts. TCG (triple chip grind) alternates a chamfered tooth with a flat raker and stands up to laminate, plastics and non-ferrous metal. Hi-ATB uses a steeper bevel for chip-free cuts in melamine and veneered plywood. ATB+R combination blades mix bevel teeth with a raker so one blade rips and crosscuts.

Freud, Diablo and Tenryu blades are stocked in our catalog and go straight into your shopping cart. Popular Tools blades ship direct from Popular’s U.S. warehouses and are ordered through their own order box on this page; they check out separately. Both orders come from the same family-owned shop in Cape Coral, Florida.

Yes. Family Hardware runs a CNC carbide saw blade sharpening service in Cape Coral with mail-in service nationwide, and free shipping both ways on 10 or more blades. Every blade in this shop can be sharpened back to its original geometry.

Kerf is the width of the cut. Thin kerf blades (under .100") remove less material, so they need less power: the right choice for contractor table saws, cordless circular saws and anyone trying to save stock. Full kerf blades (.100" and up) run truer on high-horsepower cabinet saws and industrial machines.

Aluminum, brass and other non-ferrous metals want a triple chip grind with a negative hook angle, such as Tenryu Alumi-Cut, Freud non-ferrous blades or Popular Tools non-ferrous series. Steel needs a dedicated ferrous blade for a dry-cut metal saw, such as Diablo Steel Demon or Tenryu Steel-Pro. Never run a wood blade in metal.