Ceiling Fan Parts Explorer
Ceiling box and downrod up top, motor in the middle, switch housing and light kit underneath. Tap a part to see what it does, the signs it is going bad, and the replacement we stock. Breaker off before you touch any of it.
X-ray
What’s going on?
All 13 parts
Shop all ceiling fans & parts (174)Tools for the job
Not sure which one you need?
Bring the old part into our Cape Coral or Fort Myers store — we’ll match it on the spot. Most repair parts are in stock, or order online for free in-store pickup.
Ceiling Fan parts guide
Fan-Rated Ceiling Box & Brace
The metal or heavy plastic box in the ceiling that carries the fan’s weight, usually hung from a brace that spans two joists.
Signs it’s failing: Fan wobbles no matter how well the blades are balanced; Box moves when you push on the fan; Box is a light-only box (not marked for fans).
Mounting Bracket
The steel plate screwed to the ceiling box. The downrod ball sits in its cradle so the fan can self-level.
Signs it’s failing: Fan wobbles or tilts; Clunk when the fan starts; Loose screws at the box.
Downrod
The pipe the fan hangs from. Its length sets how far the blades sit below the ceiling.
Signs it’s failing: Fan wobbles (bent rod or loose pin); Blades too close to the ceiling or too low; Missing cross pin or clip.
Canopy
The cover that slides up the downrod and hides the bracket, wiring and (often) the remote receiver.
Signs it’s failing: Rattles or hums; Hangs below the ceiling; Cracked or missing screws.
Motor & Housing
The motor that spins the blades, inside the decorative housing. The reverse switch is usually on the side.
Signs it’s failing: Hums but won’t spin after the capacitor checks out; Burning smell; Grinding from worn bearings.
Fan Blades
The paddles that move the air. A set is weight-matched at the factory.
Signs it’s failing: Wobble; Warped or drooping blade; Cracked or peeling finish.
Blade Irons
The metal arms that bolt the blades to the motor.
Signs it’s failing: Wobble or one blade sits lower than the others; Clicking as the fan turns; Cracked arm.
Switch Housing
The cup under the motor that holds the speed switch and capacitor, with the light kit attached below.
Signs it’s failing: Rattles; Loose or missing screws; Light kit hangs crooked.
Light Kit
The light fixture under the fan: the fitter, sockets and glass globe or bowl.
Signs it’s failing: Light flickers or won’t come on with good bulbs; Scorched socket; Broken glass.
Light Bulbs
Most fans take medium (E26) or candelabra (E12) bulbs. Check the base before you buy.
Signs it’s failing: Light out; Flickers or dims; Bulbs burn out fast (heat or shaking).
Pull Chain Switch
The chain switches that cycle the fan speeds and turn the light on and off.
Signs it’s failing: Chain broke off or pulled out; Stuck on one speed; Clicks but nothing changes.
Remote & Receiver
The handheld remote and the receiver module, usually tucked into the canopy, that switches the fan and light.
Signs it’s failing: Fan and light ignore the remote; Works only at close range; Fan turns on or changes by itself.
Capacitor
The small box in the switch housing that starts the motor and sets the speeds.
Signs it’s failing: Runs slow on every speed; Only one speed works; Hums but won’t start, spins if you push it.